CAD 805AE Mono Block

אחד המגברי מונובלוק הטובים והמוזיקליים בעולם ועכשיו בגירסתו החדשה Anniversary Edition
נבחר ע"י המבקרים לאחד מ-100 המוצרים הטובים אשר יוצרו אי פעם בעולם האודיו.
מעגל סינגל אנדד איכותי Class A
50 וואט לכל צד.
ללא ספק ה- 805 מבית Cary נחשב למונובלוק רפרנס עולמי.

תיאור מוצר

ABOUT THE CAD-805AE AMPLIFIER

Single-end triode (SET) tube amplifiers have long been considered the Holy Grail of music reproduction systems, operating in the purest form of class-A power output. Cary Audio began in 1989 by producing a SET monoblock amplifier as its first product, and today the CAD-805AE proudly carries on that tradition. Using just one tube to handle the entire musical signal typically does not allow for more than a few watts of output power, but the CAD-805AE, with its massive power supply, is able to produce over 50 watts.

Cary Audio always hand-builds their tube products and carefully matches the tubes. In the case of the CAD-805AE monoblocks, this even extends to giving you two very different types of output tubes as standard. These two tubes have a quite different sonic character from each other, and by giving you both you can fine tune your system to best match your musical taste, your speakers, and your room’s acoustic signature. A pair of these monoblocks represent the pinnacle of today’s tube design capability, and will make your system sing as never before. If you want the very best and most accurate musical response in your home, audition the CAD-805AE.

The following section describes the CAD-805AE basic specifications. The specifications are subject to change without notice or obligation.

Circuit Type	Single-Ended Class A1/A2
Power Output	50 watts
Input Sensitivity	1.0 Volt for full output
Noise and Hum	-80 dB below full output
Frequency Response	20 Hz to 20 KHz +/- 0.75 dB
Inputs	Single-Ended RCA (Optional Balanced XLR)150 K Ohms input impedance
Tubes	2 ea – 6SN7 Input 1 ea – 300B Driver 1 ea – 845 Output + 1 ea – 211 Output 1 ea – 1629 ‘Cat Eye’ output level tube
Power Transformer	1 ea – EI Laminate, 200% Duty Cycle
Output Transformer(s)	1 ea – EI Laminate, Air Gap, 200% Duty Cycle4, 8 or 16 Ohm speaker connections
Resistors	1% Metal Film
Capacitors	Oil-filled Coupling
Power Supply Capacitors	4 ea – 1500µF @ 450 VDC
AC Cord	3 Conductor, Detachable
AC Power Requirements	117/234 VAC @ 50/60 Hz
Consumption	230 watts – Operation 76 watts – Standby
Warm-Up Time	5 Minutes
Break-In Time	100 hours of playing time
Finish	Anthracite black chassis with silver or black aluminum faceplate
Weight	80 lbs
Dimensions	8.5″ H x 12.25″ W x 24 ” D